Vertical growing frame

Step one
Cut one end of each of the 2m timber lengths into a point, as shown.

Step two
Apply one coat of Resene Kwila Timber Stain to all lengths of timber, and allow to dry. Then apply a second coat, allowing it to dry.

Step three
Create your first frame by aligning one 800mm length with the flat top of two of the 2m lengths (so the bottom points down). Position the lower horizontal 800mm length 500mm up from the pointed end of the 2m lengths to create a rectangular frame. Join the frame together using the corner brackets, drilling pilot holes first. Once all the four corners are securely fastened, flip the frame over and repeat on the other side, being careful not to allow the screws to collide as you secure each corner bracket.

Step four
Lay one 1500mm-length section of wire flower mesh over the frame and secure in place with U-nails.

Step five
Repeat steps 3 and 4 to make a second frame.

Step six
Lay the two frames down, wire side up, with the short top ends touching. Connect the frames with two hinges, drilling pilot holes first.