b'2 2 a Step 2: Cut the top of the poles off level. Cut angles if desired onto the ends of the two beams with the skill saw, and nish off with the belt sander.Usingtherouter, house the T brackets into the beams until ush. Cut angles ifdesired,ontotheends oftherafterswiththe compoundslidingsaw,and nish off with the belt sander. Step 3: Cut notches out of 3 the rafters with the router, to slot over the beams. Pre-stain the cedar with one coatthis will make it easier later on.Step 4: Lift the beams into place, drill and bolt them to the top of the posts. Step5:Spacetherafters evenly along the beam, slot andscreweachoneinto place.Spacethebattens evenly on top of the rafters. 4 5 Screw in place.Step 6: You can simply stain thepinepostsbutweve chosentocoverthemwith cedar. Measure and cut the cedarfacingboardstot. Nail in place and stain.Step 7: Apply a second coat of Resene Woodsman stain to the entire structure.6 7K eep aneye out onH irepools F acebookpag e lik e th em f or more tips an d special of f ers.buildersNick and John from All equipment and expertise Nick Devcich Construction Ltd from Hirepool. Visit www.hirepool.co.nz picturesMark Heaslip or call 0800 15 15 15.'