b'Resene Bling BlingResene Pearl LustaResene WoodstockStep 3 Secure the leading edge of the wire mesh to one of the front outside supports. Encase each bin in mesh on the sides and back, stapling the wire to the corner posts and framing as you go. The wire will let air into the bins, while still keeping the compost contained Step 4Measure and cut half rounds. Youll need one length for each vertical face of the bin fronts, and enough to close in the fronts of the bins horizontally from ground level to the top.These will easily lift out to allow for the turning and removal of compost. Step 5Nail one length of half round to each front vertical side of the bins, with a few centimetres overhang on the inside edge. Cut a length of trellis beading to the same height. Measure back from the half round to slightly more than the cross-section width of a piece of half round and nail the beading to the vertical support. Step 6 Step 7 Drop each of the half rounds into the slots between the facing half rounds and the xx beading. This closes the front of the bins.| 83'