The condition can also occur over painted knots of other wood species including some types of pine, and it can sometimes be observed where previously painted pine has peeled down to the bare wood, permitting the staining material to rise to the surface.
To avoid staining, bare wood should be primed with Resene Wood Primer. This primer will keep the wood tannins from bleeding into the topcoat, except in the most severe cases.
Note that for cedar, a pre-treatment with Resene TimberLock is strongly recommended. This is to help bind up and strengthen the timber surface of the very soft cedar.
Stains usually appear immediately but may appear after rain. A barrier coat of enamel paint or using solventborne stains is the only way to fix these problems.
Imported hardwoods may also stain and decking timber left unpainted can cause stain splashes onto surrounding painted weatherboards or staining to other surfaces.
Always test the finish you plan to use with a Resene testpot. If you see tannin staining occurring then ensure you seal the surface with an enamel primer or use a solventborne stain system.
Any personal data, such as name, address, phone, email details, supplied to Resene for the purposes of receiving newsletters, orders etc will be retained by Resene Paints Ltd. These will not be passed onto third parties. If you wish to opt out of communication from Resene please complete our contact us form.
Colours shown on this website are a representation only. Please refer to the actual paint or product sample. Resene colour charts, testpots and samples are available for ordering online. See measurements/conversions for more details on how electronic colour values are achieved.
|Australia: PO Box 924, Beenleigh, Queensland 4207
Phone: 1800 738 383. Fax: 1800 064 960
Email: email@example.com. Web: www.resene.com.au
|New Zealand: PO Box 38242, Wellington Mail Centre, Lower Hutt 5045
Phone: +64 (4) 577 0500, 0800 RESENE (737 363), Fax: +64 (4) 577 0600
Email: firstname.lastname@example.org. Web: www.resene.co.nz